User’s Manual for ATS 4121CL 2.4GHz Digital Spread Spectrum Cordless Telephone To fully enjoy all the benefits of this product, we ask
10 PRIVATE NUMBER or TALK 1:32:56 UNKNOWN NUMBER Call with Caller ID (number and name or an associated number in the Phone book): TALK 1:32:56
11 display. The Handset returns to the idle screen after 5 seconds. If the Handset is put in the cradle, it returns to the idle screen immediate
12 the event redial memory is empty. Press Talk/End to dial the displayed number. -OR- Press Talk/End and listen for dial tone. Now, press RED
13 c) Information------ 411 To use any of these PPU features: 1) Press the desired PPU access key. 2) The phone automatically goes off-hook and
14 Call Log (Caller ID) All incoming calls with a valid Caller ID provided phone number are stored in the call log. Name and time/date infor
15 deleting. By selecting CANCEL, the phone returns to the Call Log. ●Storing the CID information displayed into the Phone Book by pressing the
16 The last entered character is deleted by pressing CLEAR or ▼. The entire name is cleared with a long CLEAR key press. Key Character versus
17 ROBERT 9898327822
18 STORE NAME
19 Ringing is switched off by adjusting the ring volume to zero. A "Ringer OFF" icon is shown in the display during idle mode. The de
2 TABLE OF CONTENTS Important Safety Instructions ...3 S
20 4) Enable key click by pressing 1 or ▲, or disable key click by pressing 0 or DOWN. KEY CLICK OFF 5) Press PROG to confirm the setting. The
21 >CALL LOG PHONE BOOK 2) Press the ▼ key eight times. >HANDSET NAME LANGUAGE
22 ●The second Base Unit indicator serves multiple purposes – specifically, Message Waiting and Line Status. This LED is sometimes red and so
23 CHARGING When the battery is charged up to a level above its nominal charge level, it will display "READY": READY NOTE: Even t
24 ●The Handset emits a double-beep two times (separated by 1 minute) when in idle (on-hook) mode. Charging: ●The Handset beeps when correct
25 Consumer Information 1. This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the back of th
26 2) According to telephone company reports, AC electrical surges, typically resulting from lightning strikes, are very destructive to teleph
27 Limited Warranty WHAT DOES OUR WARRANTY COVER? * Any defect in material and workmanship. FOR HOW LONG AFTER THE ORIGINAL PURCHASE? *
3 Important Safety Instructions BEFORE USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK O
4 controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation. e.
5 Handset and Base Layouts 12345678109121113141516 1 Dialing Keys (0-9; *; #) 9 Message Waiting Indicator (LED) 2 Talk / End
6 171819 17 Message Waiting/In Use Indicator 19 Page 18 Charge Indicator LCD Display
7 1. Caller ID Time 2. Caller ID Date 3. Ringer OFF icon (displayed when user turns the ringer off) 4. Low battery icon (on only if battery volt
8 6 Snap the bracket into place on the back of the Base. If you are using the tabletop bracket, run the two cords through the channel at the
9 call’. The caller ID either shows the calling number alone: 987-654-3210 or, in addition to that, caller’s name and time/date information.
Kommentare zu diesen Handbüchern